Toyota Camry (XV70): Disassembly
DISASSEMBLY
PROCEDURE
1. REMOVE NO. 1 SLIDING ROOF SIDE GARNISH LH
(a) Using a heat light, heat the No. 1 sliding roof side garnish LH.
Heating Temperature|
Item | Temperature |
|---|---|
|
No. 1 Sliding Roof Side Garnish LH |
20 to 30 |
READ NEXT:
Reassembly
REASSEMBLY PROCEDURE 1. INSTALL SUNSHADE TRIM SUB-ASSEMBLY
(a) Install the sunshade trim sub-assembly as shown in the illustration.
*A RH Side
*B LH Side
*a Re
Installation
INSTALLATION PROCEDURE 1. INSTALL SLIDING ROOF HOUSING ASSEMBLY
(a) Pass a string under the windshield outside moulding as shown in the illustration.
*1 Windshield Outside Moulding
SEE MORE:
Removal
REMOVAL PROCEDURE 1. REMOVE FRONT FENDER APRON SEAL RH
Click here
2. DRAIN ENGINE OIL Click here
3. REMOVE ENGINE OIL PRESSURE SWITCH ASSEMBLY
(a) Disengage the clamp to disconnect the wire harness protector.
*1 Wire Harness Protector
Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3.
(b) Turn the ignition switch to ON. (c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Main Body / Trouble Codes. Body Electrical > Main Body > Trouble Codes
(e) Check the details of the DTCs. Clic
© 2023-2026 Copyright www.tocamry.com
