Toyota Camry (XV70): Dtc Check / Clear
DTC CHECK / CLEAR
CHECK DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Telematics / Trouble Codes.
Body Electrical > Telematics > Trouble Codes
(e) Check for DTCs and write them down.
(f) Check the details of the DTC(s).
Click here
CLEAR DTC
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Telematics / Clear DTCs.
Body Electrical > Telematics > Clear DTCs
(e) Clear the DTCs.
READ NEXT:
DATA LIST / ACTIVE TEST DATA LIST NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a
DIAGNOSTIC TROUBLE CODE CHART Safety Connect System
DTC No. Detection Item
Link B153711
Telephone Sub Antenna Circuit Short to Ground
B153713 Telephone Sub An
VEHICLE CONTROL HISTORY NOTICE: Make sure to record any output Vehicle Control History codes before clearing them and checking the Vehicle Control History again.
CHECK VEHICLE CONTROL HISTORY NOTICE
SEE MORE:
REPLACEMENT CAUTION / NOTICE / HINT
CAUTION: Do not remove the radiator cap sub-assembly or radiator drain cock plug while the engine and radiator assembly are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.
PROCEDURE
1. DRAIN ENGINE COOLANT CAUTI
ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. REMOVE REAR WHEEL Click here
2. DISCONNECT NO. 2 PARKING BRAKE WIRE ASSEMBLY
Click here 3. SEPARATE REAR DISC BRAKE C