Toyota Camry owners & service manuals

Toyota Camry (XV70): Dtc Check / Clear

Toyota Camry Repair Manual XV70 (2018-2024) / Engine, Hybrid System / Cruise Control / Road Sign Assist System / Dtc Check / Clear

DTC CHECK / CLEAR

CHECK FOR DTC

(a) Check for DTCs (Test Failed / Pending / Confirmed).

Body Electrical > Road Sign Assist > Trouble Codes

Techstream Display

Description

Test Failed

Shows the malfunction judgment results during the current trip.

Pending

Shows the malfunction judgment results up to now. (Indicates the possibility of a malfunction when no DTC is confirmed.)

Confirmed

Shows the DTCs confirmed up to now. (The number of current trips differs for each DTC.)

HINT:

Freeze frame data is stored respectively for pending DTCs, confirmed DTCs and the latest DTCs.

CLEAR DTC

(a) Clear the DTCs.

Body Electrical > Road Sign Assist > Clear DTCs

HINT:

DTCs and freeze frame data are cleared at the same time.

    READ NEXT:

     Freeze Frame Data

    FREEZE FRAME DATA DESCRIPTION (a) Whenever a road sign assist system DTC is stored, the forward recognition camera stores the current vehicle state (ECU and sensor information) as Freeze Frame Data.

     Fail-safe Chart

    FAIL-SAFE CHART FAIL-SAFE FUNCTION (a) When a malfunction occurs in the road sign assist system, a message will be displayed on the multi-information display and the road sign assist system will be di

     Data List / Active Test

    DATA LIST / ACTIVE TEST DATA LIST NOTICE: In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a

    SEE MORE:

     Mute Signal Circuit between Radio Receiver and Telematics Transceiver

    DESCRIPTION The DCM (telematics transceiver) sends a mute signal to the radio and display receiver assembly. The radio and display receiver assembly controls the volume according to the mute signal from the DCM (telematics transceiver). WIRING DIAGRAM CAUTION / NOTICE / HINT NOTICE: Depen

     Voice is not Recognized

    PROCEDURE 1. CHECK CONDITION (a) While paying attention to the condition of the spoken voice command, perform a voice recognition operation. OK: Voice command is recognized normally. HINT: When the voice command is recognized, the content of the voice command is displayed in t

    © 2023-2026 Copyright www.tocamry.com