Toyota Camry (XV70): Freeze Frame Data
FREEZE FRAME DATA
DESCRIPTION
(a) Whenever a road sign assist system DTC is stored, the forward recognition camera stores the current vehicle state (ECU and sensor information) as Freeze Frame Data.
CHECK FREEZE FRAME DATA
(a) Select a DTC to display the freeze frame data.
Body Electrical > Road Sign Assist > Trouble Codes(b) Check the freeze frame data for the output DTC.
FREEZE FRAME DATA CHART
Body Electrical > Road Sign Assist|
Tester Display | Measurement Item |
Range | Normal Condition |
Diagnostic Note |
|---|---|---|---|---|
|
Total Distance Traveled |
- | - |
- | Cannot be used |
|
Total Distance Traveled - Unit |
- | - |
- | Cannot be used |
|
Traffic Sign Estimated Speed Unit |
- | - |
- | Cannot be used |
|
Traffic Sign Estimated Traffic Division |
- | - |
- | Cannot be used |
|
RSA Navigation Fusion Control |
RSA navigation fusion control setting |
OFF or ON | OFF: RSA navigation fusion control off ON: RSA navigation fusion control on |
- |
READ NEXT:
Fail-safe Chart
FAIL-SAFE CHART FAIL-SAFE FUNCTION (a) When a malfunction occurs in the road sign assist system, a message will be displayed on the multi-information display and the road sign assist system will be di
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE:
In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Road Sign Assist System
DTC No. Detection Item
Link U010087
Lost Communication with ECM/PCM "A" Missing Message
U012587 Lost Com
SEE MORE:
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during rear suspension member sub-assembly removal/installation are shown below. Necessary Procedures After
RCTA (Rear Cross Traffic
Alert)
The RCTA function uses the BSM rear side radar sensors
installed behind the rear bumper. This function is intended to
assist the driver in checking areas that are not easily visible
when backing up.
System components
Multi-information display
Turning the RCTA function on/off.
Outside r
