Toyota Camry (XV70): Electric Parking Brake Actuator (C13B800)
DESCRIPTION
|
DTC No. | Detection Item |
DTC Detection Condition | Trouble Area |
Memory | Note |
|---|---|---|---|---|---|
|
C13B800 | Electric Parking Brake Actuator |
|
| DTC stored |
An electric parking brake system malfunction is displayed on the multi-information display. |
|
Vehicle Condition | |||
|---|---|---|---|
|
Pattern 1 | Pattern 2 | ||
|
Diagnosis Condition | Electric parking brake operating |
○ | ○ |
|
Malfunction Status | Free spinning detected |
○ | - |
|
Repeated slipping detected |
- | ○ | |
|
Detection Time | - |
- | |
|
Number of Trips | 1 trip |
1 trip | |
CAUTION / NOTICE / HINT
NOTICE:
- Although DTC C13B800 may be stored after entering pad replacement mode, this is not a malfunction.
- Although DTC C13B800 may be stored after forcibly releasing the parking brake, this is not a malfunction.
PROCEDURE
|
1. | CHECK DTC |
(a) Using the Techstream, check for DTCs other than DTC C13B800.
Chassis > Brake > Trouble Codes|
Result | Proceed to |
|---|---|
|
Only DTC C13B800 is output |
A |
| DTCs other than C13B800 are output |
B |
| B |
.gif) | GO TO DIAGNOSTIC TROUBLE CODE CHART |
|
.gif)
| 2. |
ELECTRIC PARKING BRAKE OPERATION CHECK |
(a) With the wheels not contacting the ground, check the condition of the rear wheels when the electric parking brake is operating and not operating.
Click here .gif)
| NEXT | | REPAIR OR REPLACE ABNORMAL WHEELS |
READ NEXT:
Electric Parking Brake does not Operate
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE: Inspect the fuses for circuits related to this system before performing the following procedure.
HINT: Even if the electric parking brake is opera
Message Not Displayed on Multi-information Display When AUTO Function Set to ON/OFF
DESCRIPTION When the AUTO function is set to ON/OFF, a message is displayed on the multi-information display in the combination meter assembly. WIRING DIAGRAM
PROCEDURE
1.
CHECK OPERATIO
Brake Warning Light (Yellow) Remains On
DESCRIPTION This procedure is for troubleshooting when the brake warning light (yellow) remains on but no DTCs are output.
The skid control ECU (brake actuator assembly) controls the brake warning l
SEE MORE:
Parts Location
PARTS LOCATION ILLUSTRATION
*1 MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY
*2 INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
- ECU-B NO. 2 FUSE - DOOR F/L FUSE - DOOR F/R FUSE - DOOR R/L FUSE
- DOOR R/R FUSE - S/ROOF FUSE (w/ Sliding Roof System or Panoramic Moon Roof System)
- S
Excessive Brake Pedal Travel (No Fluid Leaks and No Air in System)
CAUTION / NOTICE / HINT NOTICE: After replacing the skid control ECU (brake actuator assembly), perform acceleration sensor zero point calibration and system information memorization.
Click here
PROCEDURE
1.
PRE-INSPECTION (a) Brake pedal inspection
(1) Perform a visual inspec
