Toyota Camry (XV70): Engine Unit
READ NEXT:
Precaution
PRECAUTION
HINT:
Any digits beyond the 1/100 mm (1/1000 in.) place for standard, minimum and maximum values should be used as a reference only.
When both standard and maximum or minimum val
Components
COMPONENTS ILLUSTRATION
*A for Type A
*B for Type B
*1 COMPRESSOR ASSEMBLY WITH MAGNETIC CLUTCH
*2 DRIVE SHAFT BEARING BRACKET
*3 ENGINE COVER BRACKET
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during e
SEE MORE:
Installation
INSTALLATION PROCEDURE 1. INSTALL LEAK DETECTION PUMP SUB-ASSEMBLY
HINT: Only perform this procedure when replacement of the leak detection pump sub-assembly is necessary.
(a) Engage the 2 claws to install a new leak detection pump sub-assembly to the No. 2 charcoal canister sub-assembly.
If the electronic key does
not operate properly (vehicles with a smart key system)
If communication between the electronic key and vehicle is
interrupted or the electronic key cannot be used
because the battery is depleted, the smart key system and wireless
remote control cannot be used. In such cases, the doors
and trunk can be opened and the engine can be started by followin
© 2023-2026 Copyright www.tocamry.com
