Toyota Camry (XV70): Front Disc Brake Pad (for 2-pot Caliper)
Toyota Camry Repair Manual XV70 (2018-2024) / Brake / Brake (front) / Front Disc Brake Pad (for 2-pot Caliper)
Components
COMPONENTS
ILLUSTRATION
|
*1 | FRONT DISC BRAKE ANTI-SQUEAL SHIM KIT |
*2 | FRONT DISC BRAKE PAD |
|
*3 | FRONT DISC BRAKE CYLINDER ASSEMBLY |
*4 | FRONT DISC BRAKE PAD WEAR INDICATOR PLATE |
|
*5 | FRONT NO. 1 DISC BRAKE ANTI-SQUEAL SHIM |
*6 | FRONT NO. 2 DISC BRAKE ANTI-SQUEAL SHIM |
|
*7 | ANTI-SQUEAL SPRING |
- | - |
.png) |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) |
- | - |
Removal
REMOVAL
CAUTION / NOTICE / HINT
Click here .gif)
Installation
INSTALLATION
CAUTION / NOTICE / HINT
Click here .gif)
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 NO. 2 PARKING BRAKE WIRE ASSEMBLY
*2 PARKING BRAKE ACTUATOR ASSEMBLY
*3 O-RING
- -
Tightening torque for "Major areas in
SEE MORE:
Installation
INSTALLATION PROCEDURE 1. TEMPORARILY TIGHTEN PROPELLER WITH CENTER BEARING SHAFT ASSEMBLY
(a) When reusing a propeller with center bearing shaft assembly and rear differential carrier assembly:
(1) Align the matchmarks on the rear differential carrier assembly and propeller with center bea
Installation
INSTALLATION CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSTALL REAR DRIVE SHAFT INBOARD JOINT SHAFT SNAP RING LH
(a) Install a new rear drive shaft inboard joint shaft snap ring LH. 2. INS
© 2023-2026 Copyright www.tocamry.com
