Toyota Camry (XV70): Front Suspension Member
READ NEXT:
COMPONENTS ILLUSTRATION
*A for A25A-FKS
*B for AWD
*1 FRONT FRAME ASSEMBLY
*2 FUEL DELIVERY GUARD
*3 STEERING GEAR HEAT INSULATOR
*4 WIRE HARNES
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during f
INSTALLATION PROCEDURE 1. INSTALL HOLE PLUG
(a) Install the 7 hole plugs to the front frame assembly. HINT:
There are 2 different shapes of hole plug.
2. INSTALL FRONT SUSPENSION MEMBER BODY MO
SEE MORE:
DTC CHECK / CLEAR NOTICE: When the diagnosis system is changed from normal mode to check mode or vice versa, all DTCs and freeze frame data recorded in normal mode are cleared. Before changing modes, always check and make a note of DTCs and freeze frame data.
HINT:
DTCs which are stored in the
CALIBRATION NOTICE: When any of the following parts have been replaced, perform adjustment shown in the following table. If not, the intuitive parking assist system may not operate correctly.
ADJUST INTUITIVE PARKING ASSIST SYSTEM (a) The necessary procedures (adjustment, calibration, initializati