Toyota Camry (XV70): Fuel Injector (for Port Injection)
Toyota Camry Repair Manual XV70 (2018-2024) / Engine, Hybrid System / 2gr-fks (fuel) / Fuel Injector (for Port Injection)
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 FUEL DELIVERY PIPE WITH SENSOR ASSEMBLY
*2 FUEL INJECTOR ASSEMBLY
*3 FUEL TUBE SUB-ASSEMBLY
*4 INJECTOR VIBRATION INSULATOR
*5
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fu
Inspection
INSPECTION PROCEDURE 1. INSPECT FUEL INJECTOR ASSEMBLY
(a) Check the resistance.
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester
SEE MORE:
Removal
REMOVAL PROCEDURE 1. REMOVE WATER INLET WITH THERMOSTAT SUB-ASSEMBLY
Click here 2. REMOVE V-RIBBED BELT
Click here 3. REMOVE NO. 2 IDLER PULLEY SUB-ASSEMBLY
(a) Remove the bolt and No. 2 idler pulley sub-assembly.
4. REMOVE WATER PUMP PULLEY
(a) Using a screw
Check Bus 1 Line for Short to GND
DESCRIPTION There may be a short circuit between one of the CAN bus lines and GND when there is no resistance between terminal 23 (CA1H) of the central gateway ECU (network gateway ECU) and terminal 4 (CG) of the DLC3, or terminal 8 (CA1L) of the central gateway ECU (network gateway ECU) and termina
© 2023-2026 Copyright www.tocamry.com
