Toyota Camry (XV70): Inspection
INSPECTION
PROCEDURE
1. INSPECT REAR STEREO COMPONENT SPEAKER ASSEMBLY
(a) With the speaker installed, check that there is no looseness or other abnormalities.
(b) Check that there is no foreign matter in the speaker, no tears on the speaker cone or other abnormalities.
| (c) Measure the resistance of the speaker. Standard Resistance: |
Tester Connection | Condition |
Specified Condition | |
1 (WF2-) - 2 (WF2+) |
Always | 4.2 to 6.4 Ω | |
3 (WF1-) - 4 (WF1+) |
Always | 4.2 to 6.4 Ω |
If the result is not as specified, replace the speaker. |
|
|
*a | Component without harness connected
(Rear Stereo Component Speaker Assembly) | | |
READ NEXT:
INSTALLATION PROCEDURE 1. INSTALL REAR STEREO COMPONENT SPEAKER ASSEMBLY
NOTICE: Do not touch the speaker cone. (a) Connect the connector.
(b) Engage the guide to temporarily install the rear ster
COMPONENTS ILLUSTRATION
*A except Panoramic Moon Roof
- -
*1 ROOF ANTENNA ASSEMBLY
*2 ROOF ANTENNA ASSEMBLY WITH COVER
*3 COVER
*4 WASHER AND HO
SEE MORE:
REMOVAL PROCEDURE 1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
Click here 2. REMOVE AIR CONDITIONER PRESSURE SENSOR
(a) Disconnect the connector.
(b) Using a 27 mm deep socket wrench, remove the air conditioner pressure sensor as shown in the illustration.
NOTICE: S
DESCRIPTION This means that the DCM (telematics transceiver) has detected a malfunction in the safety connect system and stored a DTC or specific vehicle control history (RoB) Code. PROCEDURE
1.
CHECK DTC (a) Turn the engine switch off.
(b) Connect the Techstream to the DLC3. (c) Tur