Toyota Camry owners & service manuals

Toyota Camry (XV70): Inspection

INSPECTION

PROCEDURE

1. INSPECT FUEL INJECTOR ASSEMBLY

NOTICE:

This inspection is for checking the fuel injector assembly for an open or short. Because the fuel injector assembly of this vehicle is a high-pressure type, fuel injection volume cannot be checked.

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

1 - 2

20°C (68°F)

1.74 to 2.04 Ω

If the result is not as specified, replace the fuel injector assembly.

*a

Component without harness connected

(Fuel Injector Assembly)

    READ NEXT:

     Installation

    INSTALLATION PROCEDURE 1. INSTALL FUEL INJECTOR SEAL (a) Apply engine conditioner to the area shown in the illustration. Using a piece of cloth, clean carbon deposits from the fuel injector asse

     Fuel Injector (for Port Injection)

     Components

    COMPONENTS ILLUSTRATION *1 FUEL DELIVERY PIPE WITH SENSOR ASSEMBLY *2 FUEL INJECTOR ASSEMBLY *3 FUEL TUBE SUB-ASSEMBLY *4 INJECTOR VIBRATION INSULATOR *5

    SEE MORE:

     Lost Communication with ECM / PCM "A" (U0100,U0126,U0129,U023A)

    DESCRIPTION The power steering ECU (rack and pinion power steering gear assembly) receives signals from the ECM, steering sensor, skid control ECU (brake actuator assembly) and forward recognition camera via CAN communication. DTC No. Detection Item DTC Detection Condition Troub

     Cold Start Ignition Timing Performance (P050B00)

    MONITOR DESCRIPTION This monitor will run when the engine is started at an engine coolant temperature of -10 to 50°C (14 to 122°F). The DTC is stored after the engine idles for 13 seconds (2 trip detection logic). The DTC is designed to monitor the ignition timing at cold start. When the engine

    © 2023-2026 Copyright www.tocamry.com