Toyota Camry owners & service manuals

Toyota Camry (XV70): Inspection

Toyota Camry Repair Manual XV70 (2018-2024) / Engine, Hybrid System / 2gr-fks (fuel) / Fuel Pump / Inspection

INSPECTION

PROCEDURE

1. INSPECT FUEL PUMP

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Specified Condition

U - V

0.05 to 3.0 Ω

V - W

0.05 to 3.0 Ω

U - W

0.05 to 3.0 Ω

If the result is not as specified, replace the fuel pump.

*a

Component without harness connected

(Fuel Pump)

    READ NEXT:

     Reassembly

    REASSEMBLY PROCEDURE 1. INSTALL FUEL PUMP HINT: Perform "Inspection After Repair" after replacing the fuel pump. Click here (a) Apply gasoline to a new O-ring. Then install the O-ring

     Installation

    INSTALLATION PROCEDURE 1. INSTALL FUEL SUCTION TUBE WITH PUMP AND GAUGE ASSEMBLY (a) Install a new fuel suction tube set gasket to the fuel tank assembly. (b) Set the fuel suction tube with pump a

     Components

    COMPONENTS ILLUSTRATION *1 REAR CENTER SEAT OUTER BELT ASSEMBLY *2 REAR SEAT CUSHION ASSEMBLY *3 REAR SEAT CUSHION LOCK HOOK *4 REAR SEAT INNER BELT ASSEMBLY RH

    SEE MORE:

     Diagnostic Trouble Code Chart

    DIAGNOSTIC TROUBLE CODE CHART Tire Pressure Warning ECU and Receiver DTC No. Detection Item Note Link B1247 Tire Pressure Monitor Receiver Communication Stop This DTC is for main body ECU (multiplex network body ECU) C2111 Transmitter ID1 Operation S

     Telephone And Gps Antenna Cords (for Roof Side)

    ComponentsCOMPONENTS ILLUSTRATION *1 TELEPHONE AND GPS ANTENNA CORD - - RemovalREMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during

    © 2023-2026 Copyright www.tocamry.com