Toyota Camry owners & service manuals

Toyota Camry (XV70): Inspection

Toyota Camry Repair Manual XV70 (2018-2024) / Engine, Hybrid System / A25a-fks (cooling) / Flow Shutting Valve (for Atf) / Inspection

INSPECTION

PROCEDURE

1. INSPECT FLOW SHUTTING VALVE (NO. 1 WATER BY-PASS HOSE)

(a) Measure the resistance according to the value(s) in the table below.

Standard Resistance:

Tester Connection

Condition

Specified Condition

1 - 2

20°C (68°F)

22 to 28 Ω

If the result is not as specified, replace the flow shutting valve (No. 1 water by-pass hose).

*a

Component without harness connected

(Flow Shutting Valve (No. 1 Water By-pass Hose))

    READ NEXT:

     Installation

    INSTALLATION PROCEDURE 1. INSTALL FLOW SHUTTING VALVE (NO. 1 WATER BY-PASS HOSE) (a) Install the flow shutting valve (No. 1 water by-pass hose) with the bolt. Torque: 19 N·m {194 kgf·cm, 14 ftÂ

     Components

    COMPONENTS ILLUSTRATION *A for TMC made - - *1 NO. 1 ENGINE UNDER COVER *2 NO. 2 ENGINE UNDER COVER ASSEMBLY *3 FRONT WHEEL OPENING EXTENSION PAD LH

     Removal

    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during fl

    SEE MORE:

     Vehicle Speed Sensor (C1A45)

    DESCRIPTION The blind spot monitor sensor receives vehicle speed signals from the skid control ECU via CAN communication. Blind Spot Monitor Master DTC No. Detection Item DTC Detection Condition Trouble Area C1A45 Vehicle Speed Sensor A fail flag is transmitted from th

     Installation

    INSTALLATION PROCEDURE 1. INSTALL HOLE PLUG (a) Install the 10 hole plugs to the rear suspension member sub-assembly. HINT: There are 2 different shapes of hole plug. 2. INSTALL REAR SUSPENSION MEMBER FRONT BODY MOUNTING CUSHION (for LH Side) (a) Confirm the installation

    © 2023-2026 Copyright www.tocamry.com