Toyota Camry owners & service manuals

Toyota Camry (XV70): Installation

INSTALLATION

PROCEDURE

1. INSTALL TRANSMISSION WIRE

(a) Coat the O-ring of the transmission wire with Toyota Genuine ATF WS.

(b) Install the transmission wire to the automatic transaxle case sub-assembly with the bolt.

Torque:

5.4 N

    READ NEXT:

     Valve Body Assembly

     Components

    COMPONENTS ILLUSTRATION *1 TRANSMISSION VALVE BODY ASSEMBLY *2 TRANSAXLE CASE GASKET *3 NO. 1 FRONT OIL PUMP COVER GASKET *4 NO. 2 FRONT OIL PUMP COVER GASKET

     Removal

    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during tr

    SEE MORE:

     Throttle / Pedal Position Sensor / Switch "A" Circuit Short to Battery or Open (P012015)

    DESCRIPTION Refer to DTC P012011. Click here DTC No. Detection Item DTC Detection Condition Trouble Area MIL Memory Note P012015 Throttle / Pedal Position Sensor / Switch "A" Circuit Short to Battery or Open The output voltage of VTA1 is higher than 4.5

     Components

    COMPONENTS ILLUSTRATION *1 REAR ENGINE OIL SEAL *2 NO. 1 CRANKSHAFT POSITION SENSOR PLATE *3 DRIVE PLATE AND RING GEAR SUB-ASSEMBLY *4 REAR DRIVE PLATE SPACER N*m (kgf*cm, ft.*lbf): Specified torque ● Non-reusable part

    © 2023-2026 Copyright www.tocamry.com