Toyota Camry (XV70): Installation
INSTALLATION
CAUTION / NOTICE / HINT
NOTICE:
This procedure includes the installation of small-head bolts. Refer to Small-Head Bolts of Basic Repair Hint to identify the small-head bolts.
Click here .gif)
PROCEDURE
1. INSTALL WATER INLET WITH THERMOSTAT SUB-ASSEMBLY
(a) Install a new gasket to the water inlet with thermostat sub-assembly.
HINT:
Be sure to clean the contact surfaces.
(b) Using an 8 mm socket wrench, install the water inlet with thermostat sub-assembly with the 2 bolts.
Torque:
10 N·m {102 kgf·cm, 7 ft·lbf}
(c) Connect the No. 7 water by-pass hose to the water inlet with thermostat sub-assembly and slide the clip to secure it.
(d) Connect the water inlet with thermostat sub-assembly connector.
2. CONNECT NO. 2 RADIATOR HOSE
Click here
3. INSTALL GENERATOR ASSEMBLY
Click here
4. ADD ENGINE COOLANT
Click here
5. INSPECT FOR COOLANT LEAK
Click here
READ NEXT:
Water Pump
ComponentsCOMPONENTS ILLUSTRATION
*1 ENGINE WATER PUMP ASSEMBLY (WATER INLET HOUSING)
*2 GASKET
N*m (kgf*cm, ft.*lbf): Specified torque
● Non-reusable
Camera Heater
ComponentsCOMPONENTS ILLUSTRATION
*1 FORWARD RECOGNITION CAMERA
*2 FORWARD RECOGNITION WITH HEATER HOOD SUB-ASSEMBLY RemovalREMOVAL PROCEDURE
1. REMOVE FORWARD RECOGNITION CAM
SEE MORE:
Replacement
REPLACEMENT PROCEDURE 1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
(a) Start the engine. (b) Operate the compressor under the following conditions:
Item Condition
Operating Time 3 minutes or more
Temperature setting Max cold
Blower speed High
Engine Id
Right Rear Wheel Speed Sensor Circuit Voltage Out of Range (C05121C)
DESCRIPTION Refer to DTC C051212 Click here
DTC No. Detection Item
DTC Detection Condition Trouble Area
C05121C Right Rear Wheel Speed Sensor Circuit Voltage Out of Range
When the vehicle is being driven in a straight line at a speed of 20 km/h (12 mph) or mor
