Toyota Camry (XV70): Installation
INSTALLATION
PROCEDURE
1. ALIGN FRONT WHEELS FACING STRAIGHT AHEAD
2. INSTALL STEERING COLUMN ASSEMBLY
NOTICE:
Make sure that the wire harness is not interfering with the steering column assembly.
(a) Install the steering column assembly with the bolt and 2 nuts.
Torque:
36 N
READ NEXT:
COMPONENTS ILLUSTRATION
*1 COWL SIDE TRIM SUB-ASSEMBLY LH
*2 FRONT DOOR OPENING TRIM WEATHERSTRIP LH
*3 FRONT DOOR SCUFF PLATE LH
*4 HOOD LOCK CONTROL LEVER
REMOVAL PROCEDURE 1. REMOVE FRONT DOOR SCUFF PLATE LH
Click here
2. REMOVE COWL SIDE TRIM SUB-ASSEMBLY LH
Click here
3. DISCONNECT FRONT DOOR OPENING TRIM WEATHERSTRIP LH
SEE MORE:
DESCRIPTION This DTC is stored when the blind spot monitor sensor LH detects an open in the outer rear view mirror indicator LH.
DTC No. Detection Item
DTC Detection Condition Trouble Area
C1AB5 Open in Outer Mirror Indicator(Slave) Both of the following conditions are met
ComponentsCOMPONENTS ILLUSTRATION
*1 ENGINE WATER PUMP ASSEMBLY (WATER INLET HOUSING)
*2 GASKET
N*m (kgf*cm, ft.*lbf): Specified torque
● Non-reusable part RemovalREMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration,