Toyota Camry (XV70): Installation
Toyota Camry Repair Manual XV70 (2018-2024) / Vehicle Exterior / Exterior Panels / Trim / Rear Spoiler / Installation
INSTALLATION
PROCEDURE
1. INSTALL REAR SPOILER RETAINER (except TRD)
HINT:
When installing a new rear spoiler retainer, heat the luggage compartment door panel and rear spoiler retainer using a heat light.
Heating Temperature|
Item | Temperature |
|---|---|
|
Luggage Compartment Door Panel |
40 to 60 |
READ NEXT:
Rear Wheel House Plate
ComponentsCOMPONENTS ILLUSTRATION
*1 FRONT ROCKER PANEL MOULDING END COVER
*2 CLIP
● Non-reusable part
- - RemovalREMOVAL CAUTION / NOTICE / HINT
Rocker Panel Moulding
ComponentsCOMPONENTS ILLUSTRATION
*1 FRONT ROCKER PANEL MOULDING END COVER
*2 ROCKER PANEL MOULDING
*3 GROMMET
*4 CLIP
● Non-reusable part
Roof Drip Side Finish Moulding
ComponentsCOMPONENTS ILLUSTRATION
*1 ROOF DRIP SIDE FINISH MOULDING
*2 ROOF DRIP SIDE FINISH MOULDING CLIP
● Non-reusable part
- - RemovalREMOVAL C
SEE MORE:
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during sliding roof housing removal/installation are shown below. Necessary Procedures After Parts Removed/I
Rear Power Window RH Auto Up / Down Function does not Operate with Rear Power Window Switch RH
DESCRIPTION If the manual up and down functions operate normally but the auto up and down functions do not, the power window control system may be in fail-safe mode.
If power window initialization has not been performed, the auto up and down functions will not operate.
Click here WIRING DIAG
© 2023-2026 Copyright www.tocamry.com
