Toyota Camry (XV70): Installation
INSTALLATION
CAUTION / NOTICE / HINT
HINT:
- Use the same procedure for the RH side and LH side.
- The following procedure is for the LH side.
PROCEDURE
1. PRECAUTION
NOTICE:
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.
Click here .gif)
2. INSTALL POWER WINDOW REGULATOR MOTOR ASSEMBLY
NOTICE:
The regulator arm must be below the intermediate position when installing the power window regulator motor assembly.
(a) Using a T25 "TORX" socket wrench, install the power window regulator motor assembly with the 3 screws.
Torque:
5.39 N
READ NEXT:
Rear Power Window Switch
ComponentsCOMPONENTS ILLUSTRATION
*1 REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY
*2 REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL Remov
Relay
On-vehicle InspectionON-VEHICLE INSPECTION PROCEDURE
1. INSPECT DEF RELAY
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Co
SEE MORE:
Control Module Performance Bank 2 Component Internal Failure (P060596,P060796)
MONITOR DESCRIPTION The ECM continuously monitors its internal processors (CPUs) and heated oxygen sensor transistors. This self-check ensures that the ECM is functioning properly.
DTC No. Detection Item
DTC Detection Condition Trouble Area
MIL Memory
Note P060596
Vehicle Speed Sensor (C1A45)
DESCRIPTION The blind spot monitor sensor receives vehicle speed signals from the skid control ECU via CAN communication. Blind Spot Monitor Master
DTC No. Detection Item
DTC Detection Condition Trouble Area
C1A45 Vehicle Speed Sensor
A fail flag is transmitted from th
© 2023-2026 Copyright www.tocamry.com
