Toyota Camry (XV70): Lost Communication with Blind Spot Monitor Master Module (U0233)
DESCRIPTION
This DTC is stored when the blind spot monitor sensor LH judges that there is a communication problem with the blind spot monitor sensor RH.
|
DTC No. | Detection Item |
DTC Detection Condition | Trouble Area |
|---|---|---|---|
|
U0233 | Lost Communication with Blind Spot Monitor Master Module |
The blind spot monitor sensor (slave) cannot receive signals from the blind spot monitor sensor (master) |
|
CAUTION / NOTICE / HINT
NOTICE:
When checking for DTCs, make sure that the blind spot monitor system is turned on.
HINT:
- Operating the engine switch, any other switches or a door triggers related ECU and sensor communication on the CAN. This communication will cause the resistance value to change.
- Even after DTCs are cleared, if a DTC is stored again after driving the vehicle for a while, the malfunction may be occurring due to vibration of the vehicle. In such a case, wiggling the ECUs or wire harness while performing the inspection below may help determine the cause of the malfunction.
PROCEDURE
|
1. | CHECK DTC OUTPUT |
(a) Turn the engine switch off.
(b) Turn the engine switch on (IG).
(c) Clear the DTCs.
Body Electrical > Blind Spot Monitor Slave > Clear DTCs(d) Check for DTCs.
Body Electrical > Blind Spot Monitor Slave > Trouble Codes|
Result | Proceed to |
|---|---|
|
DTC U0233 is output | A |
|
No DTCs are output | B |
| B |
.gif) | USE SIMULATION METHOD TO CHECK
|
|
.gif)
| 2. |
REPLACE BLIND SPOT MONITOR SENSOR RH |
Click here
.gif)
|
| 3. |
CHECK DTC OUTPUT |
(a) Check for DTCs.
Body Electrical > Blind Spot Monitor Slave > Trouble Codes|
Result | Proceed to |
|---|---|
|
DTC U0233 is output | A |
|
No DTCs are output | B |
| A |
| REPLACE BLIND SPOT MONITOR SENSOR LH
|
| B |
| END (BLIND SPOT MONITOR SENSOR RH WAS DEFECTIVE) |
READ NEXT:
Software Incompatibility with Body Control Module "B" (U1331)
DESCRIPTION This DTC is stored when the destination information of the main body ECU (multiplex network body ECU) does not match that of the blind spot monitor sensors. Blind Spot Monitor Master
Buzzer does not Sound
WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE:
When checking for DTCs, make sure that the blind spot monitor system is turned on.
Inspect the fuses for circuits related to this system be
Power Source Circuit
DESCRIPTION This circuit provides power to operate the blind spot monitor sensor. WIRING DIAGRAM
CAUTION / NOTICE / HINT
NOTICE: Inspect the fuses for circuits related to this system before perfo
SEE MORE:
Camshaft Position Sensor "B" Bank 1 Signal Stuck in Range (P03652A,P036531,P039031)
DESCRIPTION Refer to DTC P036511. Click here
DTC No. Detection Item
DTC Detection Condition Trouble Area
MIL Memory
Note P03652A
Camshaft Position Sensor "B" Bank 1 Signal Stuck in Range
No VVT sensor (for exhaust camshaft of bank 1) signal to ECM while
Lack of Power
DESCRIPTION
Problem Symptom Suspected Area
Trouble Area
Engine speed fluctuation due to abnormal combustion
Idle speed too low or high
Strong engine vibration due to above symptoms
Ignition malfunction
Deviation in air fuel ratio (Excessive or i
