Toyota Camry (XV70): Millimeter Wave Radar Sensor
Toyota Camry Repair Manual XV70 (2018-2024) / Engine, Hybrid System / Cruise Control / Millimeter Wave Radar Sensor
- Components
- Removal
- Installation
- Before Starting Driving Adjustment
- Driving Adjustment
- Target Adjustment(triangle Target)
- Target Adjustment(flat Surface Target)
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 COOL AIR INTAKE DUCT SEAL
*2 MILLIMETER WAVE RADAR SENSOR ASSEMBLY
N*m (kgf*cm, ft.*lbf): Specified torque
- -
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are replaced during millimeter wave radar senso
Installation
INSTALLATION PROCEDURE 1. INSTALL MILLIMETER WAVE RADAR SENSOR ASSEMBLY
NOTICE: If the millimeter wave radar sensor assembly has been struck or dropped, replace the millimeter wave radar sensor asse
SEE MORE:
Torque Converter Clutch Circuit Short to Ground (P074011)
DESCRIPTION Solenoid (SL) valve is turned on and off by signals from the ECM to control the hydraulic pressure acting on the lock-up relay valve, which then controls operation of the lock-up clutch.
DTC No. Detection Item
DTC Detection Condition Trouble Area
MIL Memory
Not
Noise Occurs
PROCEDURE
1. CHECK NOISE CONDITION
(a) Check from which direction the noise comes (front left or right, or rear left or right).
OK: The location of the noise source can be determined.
NG
GO TO STEP 3
OK
2.
CHECK SPEAKERS (a
© 2023-2026 Copyright www.tocamry.com
