Toyota Camry (XV70): Parking Brake Assembly
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 NO. 1 PARKING BRAKE SHOE ASSEMBLY
*2 PARKING BRAKE SHOE ADJUSTING HOLE PLUG
*3 PARKING BRAKE SHOE ADJUSTING SCREW SET
*4 PARKING BRAKE
Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
PROCEDURE 1. REMOVE REAR WHEEL Click here
Inspection
INSPECTION PROCEDURE 1. INSPECT BRAKE DISC INSIDE DIAMETER
(a) Using a brake drum gauge or an equivalent tool, measure the inside diameter of the rear disc.
Standard Inside Diameter: 173 mm
SEE MORE:
Mute Signal Circuit between Radio Receiver and Stereo Component Amplifier
DESCRIPTION This circuit sends a signal to the stereo component amplifier assembly to mute noise. Because of that, the noise produced by changing the sound source ceases.
If there is an open in the circuit, noise can be heard from the speakers when changing the sound source.
If there is a short
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced starter assembly removal/installation are shown below. Necessary Procedures After Parts Removed/Installed/Rep
© 2023-2026 Copyright www.tocamry.com
