Toyota Camry owners & service manuals

Toyota Camry (XV70): Reassembly

Toyota Camry Repair Manual XV70 (2018-2024) / Brake / Parking Brake / Parking Brake Assembly / Reassembly

REASSEMBLY

CAUTION / NOTICE / HINT

HINT:

  • Use the same procedure for the LH side and RH side.
  • The following procedure is for the LH side.

PROCEDURE

1. INSTALL PARKING BRAKE SHOE HOLD DOWN SPRING PIN (for Rear Side)

(a) Install the parking brake shoe hold down spring pin to the backing plate.

(b) Temporarily install the backing plate to the rear axle carrier sub-assembly with the nut.

NOTICE:

Do not twist the No. 3 parking brake cable assembly when installing the backing plate.

HINT:

Fully tighten the nut after installing the rear axle hub and bearing assembly.

(c) Install the rear axle hub and bearing assembly to the rear axle carrier sub-assembly with the 4 bolts.

Torque:

90 N

    READ NEXT:

     Parking Brake Cable (for Front Side)

     Removal

    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during N

     Installation

    INSTALLATION PROCEDURE 1. INSTALL NO. 1 PARKING BRAKE CABLE ASSEMBLY (a) Install the No. 1 parking brake cable assembly with the 3 bolts and nut. Torque: Bolt: : 15.5 N

    SEE MORE:

     Components

    COMPONENTS ILLUSTRATION *1 FUEL DELIVERY PIPE WITH SENSOR ASSEMBLY *2 FUEL INJECTOR ASSEMBLY *3 FUEL TUBE SUB-ASSEMBLY *4 INJECTOR VIBRATION INSULATOR *5 NO. 1 DELIVERY PIPE SPACER *6 NO. 5 ENGINE WIRE (for Bank 1) *7 NO. 5 ENGINE WIR

     Components

    COMPONENTS ILLUSTRATION *1 ENGINE WIRE *2 NO. 1 VACUUM HOSE CONNECTOR *3 VACUUM PUMP ASSEMBLY *4 NO. 1 VACUUM PUMP O-RING Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf

    © 2023-2026 Copyright www.tocamry.com