Toyota Camry (XV70): Installation
INSTALLATION
PROCEDURE
1. INSTALL NO. 1 PARKING BRAKE CABLE ASSEMBLY
| (a) Install the No. 1 parking brake cable assembly with the 3 bolts and nut. Torque: Bolt: : 15.5 N |
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 REAR CENTER SEAT OUTER BELT ASSEMBLY
*2 REAR SEAT CUSHION ASSEMBLY
*3 REAR SEAT CUSHION LOCK HOOK
*4 REAR SEAT INNER BELT ASSEMBLY RH
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during N
SEE MORE:
Microphone
ComponentsCOMPONENTS ILLUSTRATION
*A for Normal Roof
*B except Normal Roof
*1 ROOF CONSOLE BOX ASSEMBLY
*2 TELEPHONE MICROPHONE ASSEMBLY
*3 ROOF CONSOLE BOX SUB-ASSEMBLY
- - RemovalREMOVAL PROCEDURE
1. REMOVE ROOF CONSOLE BOX ASSEMBLY Clic
Intake Air Temperature Sensor 1 Bank 1 Circuit Short to Battery or Open (P011015)
DESCRIPTION Refer to DTC P011011. Click here
HINT: When DTC P011015 is stored, the ECM enters fail-safe mode. During fail-safe mode, the intake air temperature is estimated to be 20°C (68°F) by the ECM. Fail-safe mode continues until a pass condition is detected, and the engine switch is then
© 2023-2026 Copyright www.tocamry.com
