Toyota Camry (XV70): Poor Sound Quality in All Modes (Low Volume)
Toyota Camry Repair Manual XV70 (2018-2024) / Audio, Visual, Telematics / Audio / Video / Audio And Visual System / Poor Sound Quality in All Modes (Low Volume)
PROCEDURE
|
1. | CHECK AUDIO SETTINGS |
(a) Set treble, middle and bass to the initial values and check that the sound is normal.
OK:
The sound returns to normal.
HINT:
Sound quality adjustment measures vary according to the type of amplifier.
| OK | .gif) | END |
|
.gif)
| 2. |
COMPARE WITH ANOTHER VEHICLE OF SAME MODEL |
(a) Compare with another vehicle of the same model which is not malfunctioning to see if there is any difference in the sound quality.
OK:
No difference is found.
| OK | | END |
| NG | | PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE
|
.gif)
READ NEXT:
Voice Guidance does not Function
CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to
Voice is not Recognized
PROCEDURE
1. CHECK CONDITION
(a) While paying attention to the condition of the spoken voice command, perform a voice recognition operation.
OK: Voice command is recognized normally.
Cellular Phone Registration Failure
CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to
SEE MORE:
Parking Support Brake function - PKSB (Parking Support
Brake)
If the Parking Support Brake detects that a collision with an object is
possible, the engine output will be restricted to restrain any increase
in the vehicle speed. (Engine output restriction control: See A below.)
Additionally, if the accelerator pedal continues to be depressed, the
brakes wil
Brake Warning Light Remains ON
DESCRIPTION This procedure is for troubleshooting when the brake system warning light (red indicator) remains on but no DTCs are output.
The skid control ECU (brake actuator assembly) controls the brake system warning light (red indicator) in the combination meter assembly via CAN communication. W
© 2023-2026 Copyright www.tocamry.com
