Toyota Camry (XV70): Portable Player cannot be Registered
CAUTION / NOTICE / HINT
HINT:
Some versions of "Bluetooth" compatible audio players may not function properly, or the functions may be limited using the radio and display receiver assembly, even if the portable audio player itself can play files.
Click here .gif)
PROCEDURE
| 1. |
CHECK THAT PORTABLE PLAYER IS "Bluetooth" AUDIO COMPATIBLE |
(a) Check if the portable player is "Bluetooth" audio compatible.
|
Result | Proceed to |
|---|---|
|
The portable player is "Bluetooth" audio compatible. |
A |
| The portable player is not "Bluetooth" audio compatible. |
B |
| B |
.gif) | USE A "Bluetooth" AUDIO COMPATIBLE PORTABLE PLAYER |
|
.gif)
| 2. |
CHECK CONNECTION PROCEDURE OF CONNECTED DEVICE |
(a) Referring to Owner's Manual, correctly register the portable player.
(b) Check that the portable player has been registered as a connected device.
HINT:
The portable player cannot be registered under any of the following conditions:
- The A2DP (Advanced Audio Distribution Profile) is not used when registering a cellular phone.
- A different portable player registration remains in the radio and display receiver assembly.
- A different radio and display receiver assembly registration remains in the portable player.
- The portable player is off.
OK:
The portable player has been registered as a connected device.
| OK | | END |
|
| 3. |
CHECK USING ANOTHER "Bluetooth" AUDIO COMPATIBLE VEHICLE OF SAME MODEL |
(a) Check if the portable player can be registered normally to another "Bluetooth" audio compatible vehicle of the same model.
OK:
The portable player can be registered.
| NG | | MALFUNCTION IN PORTABLE PLAYER |
|
| 4. |
REMOVE ADDITIONAL DEVICES WHICH USE RADIO WAVES |
(a) Remove additional devices which use radio waves.
(b) Place the portable player close to the radio and display receiver assembly.
(c) Check that the portable player can be registered as a connected device.
OK:
The portable player can be registered.
| OK | | END |
| NG | | PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE
|
READ NEXT:
USB Audio System Recognition/Play Error
DESCRIPTION When a USB device or "iPod" is connected to the USB jack of the No. 1 stereo jack adapter assembly, it must have playable files. The device must also communicate with and be recognized by
Black Screen
PROCEDURE
1. CHECK DISPLAY SETTING
(a) Check that the display is not in screen off mode. OK: The display setting is not in screen off mode.
NG
CHANGE SCREEN TO SCREEN ON MODE
Steering Pad Switch Circuit
DESCRIPTION This circuit sends an operation signal from the steering pad switch assembly to the radio and display receiver assembly.
If there is an open in the circuit, the audio system cannot be op
SEE MORE:
Blind Spot Monitor Master Module Beam Axis Inspection Incomplete (C1ABB)
DESCRIPTION This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor RH.
HINT: This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that a beam axis inspection is performed. Completing the beam ax
Inspection
INSPECTION PROCEDURE 1. INSPECT SHIFT PADDLE SWITCH (TRANSMISSION SHIFT SWITCH ASSEMBLY)
(a) Shift Paddle Switch LH (Transmission Shift Switch Assembly):
(1) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection Condition
