Toyota Camry (XV70): Precaution
PRECAUTION
PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.
|
System Name | See Procedure |
|---|---|
|
Lane Tracing Assist System |
|
|
Pre-collision System | |
|
Parking Support Brake System | |
|
Parking Assist Monitor System | |
|
Panoramic View Monitor System |
.gif)
IGNITION SWITCH EXPRESSIONS
(a) The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.
|
Expression | Ignition Switch (Position) |
Engine Switch (Condition) |
|---|---|---|
|
Ignition Switch off | LOCK |
Off (Lock) |
|
Ignition Switch ACC | ACC |
On (ACC) |
| Ignition Switch ON |
ON | On (IG) |
|
Engine Start | START |
On (Start) |
READ NEXT:
Parts Location
PARTS LOCATION ILLUSTRATION
*1 MULTIPLEX NETWORK MASTER SWITCH ASSEMBLY
*2 INSTRUMENT PANEL JUNCTION BLOCK ASSEMBLY
- ECU-B NO. 2 FUSE - DOOR F/L FUSE - DOOR F/R FUSE - DOOR R/L
System Diagram
SYSTEM DIAGRAM DOOR BUS LINES
CERTIFICATION BUS LINES (w/ Smart Key System)
System Description
SYSTEM DESCRIPTION LIN COMMUNICATION SYSTEM DESCRIPTION
The LIN communication system is used for communication between the components in the tables below. If communication cannot be performed throug
SEE MORE:
Turn signal lever
Operating instructions
Right turn
Lane change to the right (move
the lever partway and release
it)
The right hand signals will flash 3
times.
Lane change to the left (move
the lever partway and release
it)
The left hand signals will flash 3
times.
Left turn
■Turn sig
Reassembly
REASSEMBLY PROCEDURE 1. INSTALL ROOF WIND DEFLECTOR PANEL SUB-ASSEMBLY
(a) Move the roof wind deflector panel sub-assembly in the direction indicated by the arrow (1) shown in the illustration to engage the 2 guides and install the roof wind deflector panel sub-assembly.
*a Guide
