Toyota Camry (XV70): Precaution
PRECAUTION
PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL
NOTICE:
When disconnecting the cable from the negative (-) battery terminal, initialize the following systems after the cable is reconnected.
|
System | See Procedure |
|---|---|
|
Lane Tracing Assist System |
|
|
Pre-collision System | |
|
Parking Assist Monitor System | |
|
Panoramic View Monitor System |
.gif)
EXPRESSIONS OF IGNITION SWITCH
The type of ignition switch used on this model differs depending on the specifications of the vehicle. The expressions listed in the table below are used in this section.
|
Expression | Ignition Switch (Position) |
Engine Switch (Condition) |
|---|---|---|
|
Ignition Switch off |
LOCK | Off (Lock) |
|
Ignition Switch ACC |
ACC | On (ACC) |
|
Ignition Switch ON |
ON | On (IG) |
|
Engine Start | START |
On (Start) |
READ NEXT:
Parts Location
PARTS LOCATION ILLUSTRATION
*A for Type A
*B for Type B
*1 HIGH PITCHED HORN ASSEMBLY
*2 LOW PITCHED HORN ASSEMBLY
*3 HORN RELAY
*4 ENGI
System Diagram
SYSTEM DIAGRAM
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE NOTICE: Before replacing the main body ECU (multiplex network body ECU), refer to Registration.*
Click here
*: w/ Smart Key System
HINT: Use the table b
SEE MORE:
Sun visors
To set the visor in the forward
position, flip it down.
To set the visor in the side position,
flip down, unhook, and
swing it to the side.
To use the side extender, place
the visor in the side position,
then slide it backward.
Vanity mirrors
Slide the cover to open.
Vehicl
Installation
INSTALLATION PROCEDURE 1. INSTALL FUEL LID LOCK WITH MOTOR ASSEMBLY
(a) Apply MP grease to the sliding parts of the fuel lid lock with motor assembly.
(b) Connect the connector. (c) Engage the claw to install the fuel lid lock with motor assembly.
(d) Engage the clamp. 2. INSTALL FUEL FILLE
© 2023-2026 Copyright www.tocamry.com
