Toyota Camry (XV70): Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
- Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order of probability in the "Suspected Area" column of the table. Check each symptom by checking the suspected areas in the order they are listed. Replace parts as necessary.
- Inspect the fuses and relays related to this system before inspecting the suspected areas below.
Front Radar Sensor System
|
Symptom | Suspected Area |
Link |
| "Pre-Collision System Radar Sensor Blocked Unavailable Clean Radar Sensor" is displayed |
Vehicle Control History |
|
READ NEXT:
TERMINALS OF ECU
NOTICE:
DTCs may be output when connectors are disconnected during inspection. Therefore, be sure to clear the DTCs using the Techstream once the inspection has been completed.
DIAGNOSIS SYSTEM DIAGNOSIS FUNCTION (a) If a malfunction is detected in the millimeter wave radar sensor assembly, the millimeter wave radar sensor assembly stores DTCs without directly informing the
DTC CHECK / CLEAR CHECK FOR DTC (a) Check for DTCs (Test Failed / Pending / Confirmed). Body Electrical > Front Radar Sensor > Trouble Codes
Techstream Display Description
Test F
SEE MORE:
DISASSEMBLY CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the LH side and RH side.
The following procedure is for the LH side.
PROCEDURE 1. REMOVE REAR WHEEL Click here
2. SEPARATE REAR DISC BRAKE CALIPER ASSEMBLY Click here
3. REMOVE PARKING BRAKE SHOE ADJUSTING
DTC CHECK / CLEAR CHECK DTC (a) Check the DTCs.
(1) Connect the Techstream to the DLC3. (2) Turn the ignition switch to ON.
(3) Turn the Techstream on. (4) Read the DTCs following the prompts on the Techstream screen. Enter the following menus: Chassis / Four Wheel Drive / Trouble Codes. Chassis