Toyota Camry (XV70): Rear Door Window Frame Moulding
Toyota Camry Repair Manual XV70 (2018-2024) / Vehicle Exterior / Exterior Panels / Trim / Rear Door Window Frame Moulding
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 REAR DOOR FRONT WINDOW FRAME MOULDING
*2 REAR DOOR WEATHERSTRIP
*3 REAR DOOR WINDOW FRAME MOULDING SUB-ASSEMBLY
*4 RIVET
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during r
Installation
INSTALLATION CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH side and LH side.
The following procedure is for the LH side.
PROCEDURE 1. INSTALL REAR DOOR WINDOW FRAM
SEE MORE:
Inspection
INSPECTION PROCEDURE 1. INSPECT ENGINE OIL LEVEL SENSOR
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection Condition
Specified Condition
1 - Body ground ON
Below 1 Ω
OFF 10 kΩ
Touch Panel Switch does not Function
CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Audio and Visual System.
Click here
When replacing the radio and display
© 2023-2026 Copyright www.tocamry.com
