Toyota Camry (XV70): Rear Suspension Member (for Awd)
Toyota Camry Repair Manual XV70 (2018-2024) / Suspension / Rear Suspension / Rear Suspension Member (for Awd)
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 SPARE WHEEL COVER ASSEMBLY
- - ILLUSTRATION
*1 LUGGAGE COMPARTMENT TRIM INNER PAD
*2 REAR CENTER SEAT OUTER BELT ASSEMBLY
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during r
Installation
INSTALLATION PROCEDURE 1. INSTALL HOLE PLUG
(a) Install the 10 hole plugs to the rear suspension member sub-assembly.
HINT: There are 2 different shapes of hole plug.
2. INS
SEE MORE:
Pressure Control Solenoid "L" Circuit Short to Battery (P08BA12)
DESCRIPTION Changing gears is performed by the ECM turning the solenoid (SL1, SL2, SL3, SL4, SL5 and SL6) valves on and off.
If an open or short occurs in any of the solenoid valve circuits, the ECM controls the remaining normal solenoid valves to allow the vehicle to be driven. If all of the sole
Installation
INSTALLATION PROCEDURE 1. INSTALL V-RIBBED BELT
HINT: When reusing the V-ribbed belt, check the ribs and back of the V-ribbed belt for wear and cracks. If wear or a crack that reaches the core (at more than 1 point) is found, replace the V-ribbed belt.
(a) Set the V-ribbed belt onto each pul
© 2023-2026 Copyright www.tocamry.com
