Toyota Camry (XV70): Reassembly
REASSEMBLY
CAUTION / NOTICE / HINT
PROCEDURE
1. TEMPORARILY TIGHTEN FRONT DISC BRAKE BLEEDER PLUG
(a) Temporarily install the front disc brake bleeder plug to the front disc brake cylinder.
HINT:
Fully tighten the front disc brake bleeder plug after bleeding the system.
2. INSTALL FRONT DISC BRAKE BLEEDER PLUG CAP
(a) Install the front disc brake bleeder plug cap to the front disc brake bleeder plug.
3. INSTALL PISTON SEAL
(a) Apply a light layer of lithium soap base glycol grease to the entire circumference of a new piston seal.
 |
Lithium Soap Base Glycol Grease |
| (b) Install the piston seal to the front disc brake cylinder. NOTICE: Securely install the piston seal into the groove of the front disc brake cylinder. |
|
4. INSTALL FRONT DISC BRAKE PISTON
(a) Apply a light layer of lithium soap base glycol grease to the entire circumference of a new cylinder boot.
|
*1 | Cylinder Boot |
|
*2 | Front Disc Brake Piston |
|
|
Lithium Soap Base Glycol Grease |
(b) Apply a light layer of lithium soap base glycol grease to the contact surfaces of the front disc brake piston.
(c) Install the cylinder boot to the front disc brake piston.
NOTICE:
Securely install the cylinder boot into the groove of the front disc brake piston.
(d) Install the front disc brake piston to the front disc brake cylinder.
NOTICE:
Do not forcibly install the front disc brake piston into the front disc brake cylinder.
5. INSTALL CYLINDER BOOT
|
(a) Install the cylinder boot to the front disc brake cylinder as shown in the illustration. NOTICE:
|
|
READ NEXT:
Installation
INSTALLATION CAUTION / NOTICE / HINT
NOTICE:
Immediately after installing the brake pads, the braking performance may be reduced. Always perform a road test in a safe place while paying attentio
Components
COMPONENTS ILLUSTRATION
*1 FRONT DISC BRAKE ANTI-SQUEAL SHIM KIT
*2 FRONT DISC BRAKE CYLINDER ASSEMBLY
*3 FRONT DISC BRAKE PAD
*4 FRONT FLEXIBLE HOSE
*5
SEE MORE:
Disassembly
DISASSEMBLY PROCEDURE 1. REMOVE OIL FILLER CAP SUB-ASSEMBLY
(a) Remove the oil filler cap sub-assembly from the cylinder head cover sub-assembly LH.
(b) Remove the oil filler cap gasket from the oil filler cap sub-assembly.
2. REMOVE SPARK PLUG Cli
Control Module Communication Bus "B" Off Bus Off (U007488,...,U015187)
DESCRIPTION The skid control ECU (brake actuator assembly) communicates with the following ECUs and sensors via CAN communication.
ECM
TCM (ECM)
Yaw rate and acceleration sensor (airbag sensor assembly)
Steering angle sensor
Power steering ECU (rack and pinion power steering gea
