Toyota Camry (XV70): Front Brake (for 2-pot Caliper)
Toyota Camry Repair Manual XV70 (2018-2024) / Brake / Brake (front) / Front Brake (for 2-pot Caliper)
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 FRONT DISC BRAKE ANTI-SQUEAL SHIM KIT
*2 FRONT DISC BRAKE CYLINDER ASSEMBLY
*3 FRONT DISC BRAKE PAD
*4 FRONT FLEXIBLE HOSE
*5
Removal
REMOVAL CAUTION / NOTICE / HINT
NOTICE:
Immediately after installing the front disc brake pads, the braking performance may be reduced. Always perform a road test in a safe place while paying at
Disassembly
DISASSEMBLY CAUTION / NOTICE / HINT
HINT: Perform the removal and installation of the front disc brake piston, cylinder boot and piston seal one side at a time. PROCEDURE
1. REMOVE FRONT DISC BRAK
SEE MORE:
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE
1. INSPECT AUTOMATIC LIGHT CONTROL SENSOR
*a Front view of wire harness connector
(to Automatic Light Control Sensor)
(a) Disconnect the M1 automatic light control sensor connector. (b) Measure the voltage and resistance according to the v
Intake Air Temperature Sensor 1 Bank 1 Circuit Short to Battery or Open (P011015)
DESCRIPTION Refer to DTC P011011. Click here
HINT: When DTC P011015 is stored, the ECM enters fail-safe mode. During fail-safe mode, the intake air temperature is estimated to be 20°C (68°F) by the ECM. Fail-safe mode continues until a pass condition is detected, and the engine switch is then
© 2023-2026 Copyright www.tocamry.com
