Toyota Camry (XV70): Replacement
REPLACEMENT
CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during automatic transaxle fluid replacement are shown below.
Necessary Procedures After Parts Removed/Installed/Replaced|
Replaced Part or Performed Procedure |
Necessary Procedure | Effect/Inoperative Function when Necessary Procedure not Performed |
Link |
|---|---|---|---|
| Replacement of automatic transaxle fluid |
ATF thermal degradation estimate reset |
The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly. |
|
PROCEDURE
1. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH
Click here
.gif)
2. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH
Click here
3. REMOVE NO. 1 ENGINE UNDER COVER
Click here
4. REMOVE REAR ENGINE UNDER COVER LH
Click here
5. REMOVE FRONT FENDER APRON SEAL LH
Click here
6. REPLACE AUTOMATIC TRANSAXLE FLUID
Click here
7. ADD SPECIFIED AMOUNT OF AUTOMATIC TRANSAXLE FLUID
Click here
8. ADJUST AUTOMATIC TRANSAXLE FLUID TEMPERATURE (when Using the Techstream)
Click here
9. ADJUST AUTOMATIC TRANSAXLE FLUID TEMPERATURE (when Not Using the Techstream)
Click here
10. ADJUST AUTOMATIC TRANSAXLE FLUID LEVEL
Click here
11. REBUILD WORK
Click here
12. INSTALL FRONT FENDER APRON SEAL LH
Click here
13. INSTALL REAR ENGINE UNDER COVER LH
Click here
14. INSTALL NO. 1 ENGINE UNDER COVER
Click here
15. INSTALL FRONT WHEEL OPENING EXTENSION PAD LH
Click here
16. INSTALL FRONT WHEEL OPENING EXTENSION PAD RH
Click here
READ NEXT:
High Temperature Adjustment
HIGH TEMPERATURE ADJUSTMENT CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed,
Adjustment
ADJUSTMENT CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced durin
SEE MORE:
Active Control Engine Mount System
DESCRIPTION LOCATION
*1 Vacuum Switching Valve (for Active Control Engine Mount System)
*2 Front Engine Mounting Insulator
*3 Rear Engine Mounting Insulator
- -
The active control engine mount system decreases engine vibration at a low engine speed using th
Cursor or Map Rotates when Vehicle Stopped
PROCEDURE
1. CHECK CONDITION
(a) Check with the customer if the vehicle has been turned by a turntable.
OK: Vehicle has not been turned by a turntable. HINT:
If the vehicle is turned on a turntable with the engine switch on (IG), the system may store the angular velocity. As
