Toyota Camry (XV70): Utility
UTILITY
Front Beam Axis Adjustment
HINT:
Front Beam Axis Adjustment is used to calibrate the beam axis of millimeter wave radar sensor assembly.
(a) Perform Front Beam Axis Adjustment according to the display on the Techstream.
for Type A
Body Electrical > Front Radar Sensor > Utility|
Tester Display |
|---|
| Front Beam Axis Adjustment |
for Type B
Body Electrical > Front Radar Sensor > Utility|
Tester Display |
|---|
| Front Beam Axis Adjustment |
Front Beam Axis Misalignment Reading
HINT:
Front Beam Axis Misalignment Reading is used to check the amount of misalignment of the millimeter wave radar sensor assembly.
(a) Perform Front Beam Axis Misalignment Reading according to the display on the Techstream.
Body Electrical > Front Radar Sensor > Utility|
Tester Display |
|---|
| Front Beam Axis Misalignment Reading |
Front Radar Acceleration Sensor Calibration
HINT:
Front Radar Acceleration Sensor Calibration is used to perform calibration of the acceleration sensor in the millimeter wave radar sensor assembly.
(a) Perform Front Radar Acceleration Sensor Calibration according to the display on the Techstream.
Body Electrical > Front Radar Sensor > Utility|
Tester Display |
|---|
| Front Radar Acceleration Sensor Calibration |
Transition to Online Axis Alignment Mode
NOTICE:
This utility transitions to online axis alignment mode of the millimeter wave radar sensor assembly.
(a) Following the instructions on the Techstream, perform "Transition to Online Axis Alignment Mode".
for Type A
Body Electrical > Front Radar Sensor > Utility|
Tester Display |
|---|
| Transition to Online Axis Alignment Mode |
for Type B
Body Electrical > Front Radar Sensor > Utility|
Tester Display |
|---|
| Transition to Online Axis Alignment Mode |
READ NEXT:
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order
Terminals Of Ecu
TERMINALS OF ECU
NOTICE:
DTCs may be output when connectors are disconnected during inspection. Therefore, be sure to clear the DTCs using the Techstream once the inspection has been completed.
Diagnosis System
DIAGNOSIS SYSTEM DIAGNOSIS FUNCTION (a) If a malfunction is detected in the millimeter wave radar sensor assembly, the millimeter wave radar sensor assembly stores DTCs without directly informing the
SEE MORE:
System Description
SYSTEM DESCRIPTION FUEL LID OPENER SYSTEM DESCRIPTION
When the fuel lid opener switch is pushed for 0.8 seconds, the main body ECU (multiplex network body ECU) turns on the fuel lid open relay to open the fuel lid.
FUNCTION OF MAIN COMPONENTS
Item Outline
Fuel lid opener swit
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE
1. INSPECT PARKING BRAKE ACTUATOR ASSEMBLY (a) With the ignition switch ON and the wheels not contacting the ground, operate the electric parking brake switch assembly to check the condition of the rear wheels when the electric parking brake is operating and not ope
