DESCRIPTION
|
DTC No. | Detection Item |
DTC Detection Condition | Trouble Area |
Memory | Note |
|---|---|---|---|---|---|
|
C061012 | Right Electric Parking Brake Actuator Control Circuit Short to Battery |
|
| DTC stored |
An electric parking brake system malfunction is displayed on the multi-information display. |
WIRING DIAGRAM
Click here
PROCEDURE
| 1. |
CHECK FOR SHORT TO +B |
(a) Turn the ignition switch off.
(b) Make sure the No. 1 parking brake wire assembly is securely installed.
(c) Disconnect the u1 parking brake actuator assembly RH connector.
| (d) Measure the voltage according to the value(s) in the table below. Standard Voltage:
|
|
| OK | | REPLACE PARKING BRAKE ACTUATOR ASSEMBLY RH |
|
| 2. |
CHECK FOR SHORT TO +B |
(a) Disconnect the uR2 No. 1 parking brake wire assembly connector.
| (b) Measure the voltage according to the value(s) in the table below. Standard Voltage:
|
|
| OK | | REPLACE NO. 1 PARKING BRAKE WIRE ASSEMBLY |
|
| 3. |
CHECK FOR SHORT TO +B |
(a) Disconnect the uR2 No. 1 parking brake wire assembly connector.
(b) Disconnect the A34 skid control ECU (brake actuator assembly) connector.
(c) Measure the voltage according to the value(s) in the table below.
|
*a | Front view of wire harness connector |
*b | (to Skid Control ECU (Brake Actuator Assembly)) |
|
*c | (to No. 1 Parking Brake Wire Assembly) |
- | - |
Standard Voltage:
|
Tester Connection | Condition |
Specified Condition |
|---|---|---|
|
uR2-2 or A34-2 (MRR+) - Body ground |
Always | Below 1 V |
|
uR2-1 or A34-3 (MRR-) - Body ground |
Always | Below 1 V |
| OK | | REPLACE SKID CONTROL ECU (BRAKE ACTUATOR ASSEMBLY) |
| NG | | REPAIR OR REPLACE HARNESS OR CONNECTOR |
Right Electric Parking Brake Actuator Control Circuit Open (C061013)
Right Electric Parking Brake Actuator Signal Stuck In Range (C06132A)
Electric Parking Brake Actuator (C13B800)
Operation Check
Precaution