Toyota Camry (XV70): Route cannot be Calculated
PROCEDURE
(a) Set another destination and check if the system can calculate the route correctly.
OK:
Route can be correctly calculated.
| OK |
| END |
READ NEXT:
PROCEDURE
1. CHECK CONDITION
(a) While paying attention to the condition of the spoken voice command, perform a voice recognition operation.
OK: Voice command is recognized normally.
CAUTION / NOTICE / HINT
NOTICE:
Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to
PROCEDURE
1. CHECK USAGE CONDITION
(a) Check that the vehicle and cellular phone meet the following conditions:
NOTICE: If changing cellular phone settings, updating software, etc. is
SEE MORE:
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during automatic transaxle assembly removal/installation are shown below. Necessary Procedure After Parts Remov
DESCRIPTION The ABS motor relay is built into the brake actuator assembly.
When the skid control ECU (brake actuator assembly) operates ABS, TRAC, VSC, brake hold or brake assist, the ABS motor relay turns ON and drives the motor pump built into the brake actuator assembly.
DTC No. Detecti