Toyota Camry owners & service manuals

Toyota Camry (XV70): Tire And Wheel

Toyota Camry Repair Manual XV70 (2018-2024) / General / Maintenance / Tire And Wheel

Components

COMPONENTS

ILLUSTRATION

*A

for Steel Wheel

*B

except Steel Wheel

*1

WHEEL ASSEMBLY

*2

AXLE HUB NUT

*3

WHEEL CAP

-

-

Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping" : N*m (kgf*cm, ft.*lbf)

-

-

Removal

REMOVAL

PROCEDURE

1. REMOVE WHEEL ASSEMBLY

(a) for steel wheel:

(1) Remove the wheel cap.

(b) Loosen the axle hub nuts approximately 90

    READ NEXT:

     Transmitter Battery(w/ Smart Key System)

    ComponentsCOMPONENTS ILLUSTRATION *1 TRANSMITTER BATTERY *2 MECHANICAL KEY *3 TRANSMITTER HOUSING COVER *4 TRANSMITTER HOUSING CASE *5 SMART KEY DOOR CO

     Transmitter Battery(w/o Smart Key System)

    ComponentsCOMPONENTS ILLUSTRATION *1 TRANSMITTER BATTERY *2 TRANSMITTER BATTERY HOUSING COVER *3 TRANSMITTER HOUSING COVER *4 TRANSMITTER HOUSING CASE RemovalR

     Ua80e Automatic Transaxle Fluid

    SEE MORE:

     Removal

    REMOVAL CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front lower No. 1 suspension arm sub-assembly removal/installation are shown below. Necessary Procedu

     Blind Spot Monitor Master Module Beam Axis Inspection Incomplete (C1ABB)

    DESCRIPTION This DTC is stored when a beam axis inspection has not been performed for the blind spot monitor sensor RH. HINT: This DTC is always stored after replacing a blind spot monitor sensor. The purpose of this DTC is to ensure that a beam axis inspection is performed. Completing the beam ax

    © 2023-2026 Copyright www.tocamry.com