Toyota Camry owners & service manuals

Toyota Camry (XV70): Wireless remote control/electronic key battery

Replace the battery with a new one if it is depleted.

You will need the following items:

  • Flathead screwdriver
  • Small flathead screwdriver
  • Lithium battery CR2032

Replacing the battery

Vehicles without a smart key system

1. Remove the key cover.

To prevent damage to the key, cover the tip of the flathead screwdriver with a rag.

Do-it-yourself maintenance

2. Remove the battery cover.

If the battery cover is difficult to remove, lift the edge to remove it.

Do-it-yourself maintenance

3. Remove the depleted battery using a small flathead screwdriver.

Insert a new battery with the "+" terminal facing up.

Do-it-yourself maintenance

4. Install the battery cover with the tab facing up.

Push the entire edge of the battery cover into the key.

Do-it-yourself maintenance

5. Install the key cover.

Align the key cover with the key and then press it straight into the key.

Make sure that the key cover is securely installed without any gaps between it and the key.

Do-it-yourself maintenance

6. Operate the or switch and check that the doors can be locked/unlocked.

Vehicles with a smart key system

1. Release the lock and remove the mechanical key.

Do-it-yourself maintenance

2. Remove the key cover.

To prevent damage to the key, cover the tip of the flathead screwdriver with a rag.

Do-it-yourself maintenance

3. Remove the depleted battery using a small flathead screwdriver.

When removing the cover, the electronic key module may stick to the cover and the battery may not be visible. In this case, remove the electronic key module in order to remove the battery.

Insert a new battery with the "+" terminal facing up.

Do-it-yourself maintenance

4. When installing the key cover and mechanical key, install by conducting 2 and 1 with the directions reversed.

5. Operate the or switch and check that the doors can be locked/unlocked.

■When replacing the key battery

Be careful not to lose the battery or any other small parts.

■Use a CR2032 lithium battery

  • Batteries can be purchased at your Toyota dealer, local electrical appliance shops or camera stores.
  • Replace only with the same or equivalent type recommended by the manufacturer.
  • Dispose of used batteries according to local laws.

■If the key battery is depleted

The following symptoms may occur:

  • The smart key system (if equipped) and wireless remote control will not function properly.
  • The operational range will be reduced.

WARNING

■Battery precautions

Observe the following precautions. Failure to do so may result in death or serious injury.

  • Do not swallow the battery. Doing so may cause chemical burns.
  • Vehicles without a smart key system: A coin battery or button battery is used in the key. If a battery is swallowed, it may cause severe chemical burns in as little as 2 hours and may result in death or serious injury.
  • Vehicles with a smart key system: A coin battery or button battery is used in the electronic key. If a battery is swallowed, it may cause severe chemical burns in as little as 2 hours and may result in death or serious injury.
  • Keep away new and removed batteries from children.
  • Vehicles without a smart key system: If the cover cannot be firmly closed, stop using the key and stow the key in the place where children cannot reach, and then contact your Toyota dealer.
  • Vehicles with a smart key system: If the cover cannot be firmly closed, stop using the electronic key and stow the key in the place where children cannot reach, and then contact your Toyota dealer.
  • If you accidentally swallow a battery or put a battery into a part of your body, get emergency medical attention immediately.

WARNING

■To prevent battery explosion or leakage of flammable liquid or gas

  • Replace the battery with a new battery of the same type. If a wrong type of battery is used, it may explode.
  • Do not expose batteries to extremely low pressure due to high altitude or extremely high temperatures.
  • Do not burn, break or cut a battery.

NOTICE

■For normal operation after replacing the battery

Observe the following precautions to prevent accidents:

  • Always work with dry hands.

    Moisture may cause the battery to rust.

  • Do not touch or move any other component inside the remote control.
  • Do not bend either of the battery terminals.

■When removing the battery cover (vehicles without a smart key system)

Do not forcibly remove the battery cover, otherwise it may be damaged.

If the battery cover is difficult to remove, lift the edge to remove it.

    READ NEXT:

     Checking and replacing fuses

    If any of the electrical components do not operate, a fuse may have blown. If this happens, check and replace the fuses as necessary. 1. Turn the engine switch off. 2. Open the fuse box cover. Eng

     Light bulbs

    You may replace the following bulbs yourself. The difficulty level of replacement varies depending on the bulb. If necessary bulb replacement seems difficult to perform, contact your Toyota dealer.

     Replacing light bulbs

    ■ Front turn signal/parking lights (bulb type) 1. Turn the bulb base counterclockwise. 2. Remove the light bulb. 3. Install a new light bulb and then install the bulb base to the light unit

    SEE MORE:

     On-vehicle Inspection

    ON-VEHICLE INSPECTION PROCEDURE 1. INSPECT RADIO SETTING CONDENSER (for High Mounted Stop Light) (a) With the radio setting condenser installed, check that there is no looseness or other abnormalities. (b) Measure the resistance of the radio setting condenser according to the value(s) in the

     Components

    COMPONENTS ILLUSTRATION *1 FRONT DISC BRAKE ANTI-SQUEAL SHIM KIT *2 FRONT DISC BRAKE PAD *3 FRONT DISC BRAKE CYLINDER ASSEMBLY *4 FRONT DISC BRAKE PAD WEAR INDICATOR PLATE *5 FRONT NO. 1 DISC BRAKE ANTI-SQUEAL SHIM *6 FRONT NO. 2 DISC BRAKE ANT

    © 2023-2024 Copyright www.tocamry.com