Toyota Camry (XV70): Maintenance and care
Toyota Camry Owner's Manual XV70 (2017-2024) / Maintenance and care
- Cleaning and protecting
- Maintenance
- Do-it-yourself maintenance
- Do-it-yourself service precautions
- Hood
- Positioning a floor jack
- Engine compartment
- Engine oil
- Engine coolant
- Brake fluid
- Battery
- Washer fluid
- Tires
- Tire pressure warning system
- Tire inflation pressure
- Wheels
- Air conditioning filter
- Wireless remote control/electronic key battery
- Checking and replacing fuses
- Light bulbs
- Replacing light bulbs
READ NEXT:
Cleaning and protecting
the vehicle exterior
Perform the following to protect the vehicle and maintain it in
prime condition:
Working from top to bottom, liberally apply water to the vehicle
body, wheel wells and underside of the vehicle
Cleaning and protecting
the vehicle interior
The following procedures will help protect your vehicle's interior
and keep it in top condition:
Protecting the vehicle interior
Remove dirt and dust using a vacuum cleaner. Wipe dirty surfaces
SEE MORE:
Installation
INSTALLATION CAUTION / NOTICE / HINT
HINT:
Use the same procedure for the RH and LH sides.
The procedure listed below is for the LH side.
PROCEDURE 1. INSTALL REAR DRIVE SHAFT INBOARD JOINT SHAFT SNAP RING LH
(a) Install a new rear drive shaft inboard joint shaft snap ring LH. 2. INS
Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (CHECK USING TECHSTREAM)
(a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON and wait for 90 seconds.
(c) Turn the Techstream on. (d) Enter the following menus: Body Electrical / Navigation System / Trouble Codes. Body Electrical > Navigation
© 2023-2026 Copyright www.tocamry.com
