Toyota Camry (XV70): "No GPS signal" mark is displayed
CAUTION / NOTICE / HINT
NOTICE:
- Depending on the parts that are replaced during vehicle inspection or maintenance, performing initialization, registration or calibration may be needed. Refer to Precaution for Navigation System.
Click here
.gif)
- When replacing the radio and display receiver assembly, always replace it with a new one. If a radio and display receiver assembly which was installed to another vehicle is used, the following may occur:
- A communication malfunction DTC may be stored.
- The radio and display receiver assembly may not operate normally.
PROCEDURE
|
1. | CHECK CABIN |
(a) Check the cabin for any object that might interrupt radio reception or additional devices which use radio waves on the instrument panel. If such an object exists, remove it and check if the "No GPS signal" mark disappears.
HINT:
The GPS uses extremely weak radio waves originating from satellites. If the signal is interrupted by obstructions or other radio waves, the GPS may not be able to properly receive the signal.
OK:
The "No GPS signal" mark disappears.
| OK | .gif) | END |
|
.gif)
| 2. |
CHECK SURROUNDINGS |
(a) Check if the vehicle is in a location where GPS signal reception is poor. If the vehicle is in such a place, relocate the vehicle and check if the "No GPS signal" mark disappears.
HINT:
The GPS uses 24 satellites in 6 orbits. At any point in time, 4 satellites should be able to pinpoint your vehicle. However, GPS signals may not reach the vehicle due to influence from the surroundings, vehicle direction and time. For examples, see the following illustration.
.png)
|
*a | Example |
*b | In a tunnel |
|
*c | In a building |
*d | Under an overpass |
|
*e | On a forest or tree-lined path |
*f | Between tall buildings |
|
*g | Under a cliff or overhang |
- | - |
OK:
The "No GPS signal" mark disappears.
| OK | | SYSTEM RETURNS TO NORMAL |
|
| 3. |
CHECK GPS INFORMATION (OPERATION CHECK) |
| (a) Enter the "System Sensors Check" screen. Refer to Check GPS & Vehicle Sensors in Operation Check. Click here |
|
.png)
(b) Check how many of the following codes appear in the "Reception number" column.
HINT:
T or P appears.
OK:
At least 3 codes appear.
| OK | | REPLACE RADIO AND DISPLAY RECEIVER ASSEMBLY
|
| NG | | PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE
|
READ NEXT:
Voice Guidance does not Function
WIRING DIAGRAM
PROCEDURE
1.
CHECK VOICE GUIDANCE SETTING (a) Check that the voice guidance settings are not off.
OK: Voice guidance settings are not off.
NG
CHANGE VOICE
Route cannot be Calculated
PROCEDURE
1. SET DESTINATION
(a) Set another destination and check if the system can calculate the route correctly.
OK: Route can be correctly calculated.
OK
END
NG
Voice is not Recognized
PROCEDURE
1. CHECK CONDITION
(a) While paying attention to the condition of the spoken voice command, perform a voice recognition operation.
OK: Voice command is recognized normally.
SEE MORE:
Tires
Replace or rotate tires in accordance with maintenance schedules
and treadwear.
Checking tires
Check if the treadwear indicators are showing on the tires. Also check
the tires for uneven wear, such as excessive wear on one side of the
tread.
Check the spare tire condition and pressure if not
No Sound can be Heard from Speakers
PROCEDURE
1. CHECK AUDIO SETTINGS
(a) In sound output setting mode, set volume, fader and balance to the initial values and check that the sound is normal.
OK: Audio system returns to normal. HINT: Sound quality adjustment measures vary according to the type of amplifier.
OK
