Toyota Camry (XV70): Camshaft Position Sensor
Toyota Camry Repair Manual XV70 (2018-2024) / Engine, Hybrid System / 2gr-fks (engine Control) / Camshaft Position Sensor
READ NEXT:
Components
COMPONENTS ILLUSTRATION
*1 VVT SENSOR (for Intake Side of Bank 1)
*2 VVT SENSOR (for Exhaust Side of Bank 1)
*3 VVT SENSOR (for Intake Side of Bank 2)
*4 VVT SENS
Removal
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during VV
Installation
INSTALLATION PROCEDURE 1. INSTALL VVT SENSOR (for Exhaust Side of Bank 2)
(a) Apply a light coat of engine oil to the O-ring of the VVT sensor. NOTICE:
If reusing the VVT sensor, be sure to inspec
SEE MORE:
On-vehicle Inspection
ON-VEHICLE INSPECTION PROCEDURE
1. CONNECT TECHSTREAM (a) Connect the Techstream to the DLC3 with the ignition switch off.
(b) Start the engine and run it at idle. (c) Turn the Techstream on.
(d) Enter the following menus: Chassis / Brake / Active Test. HINT:
Refer to the Techstream operator
Components
COMPONENTS ILLUSTRATION
*1 LOWER STEERING COLUMN COVER SUB-ASSEMBLY
*2 TURN SIGNAL SWITCH
*3 UPPER STEERING COLUMN COVER
- -
© 2023-2026 Copyright www.tocamry.com
