Toyota Camry (XV70): Components
COMPONENTS
ILLUSTRATION
*1 | NO. 2 ENGINE UNDER COVER ASSEMBLY |
*2 | V-RIBBED BELT |
*3 | FRONT WHEEL OPENING EXTENSION PAD LH |
*4 | FRONT WHEEL OPENING EXTENSION PAD RH |
*5 | NO. 1 ENGINE UNDER COVER |
- | - |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
- | - |
READ NEXT:
REMOVAL PROCEDURE 1. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH
Click here
2. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH Click here
3. REMOVE NO. 1 ENGINE UNDER COV
INSTALLATION PROCEDURE 1. INSTALL V-RIBBED BELT
HINT: When reusing the V-ribbed belt, check the ribs and back of the V-ribbed belt for wear and cracks. If wear or a crack that reaches the core (at m
ComponentsCOMPONENTS ILLUSTRATION
*1 CENTER NO. 4 ENGINE UNDER COVER
- - ILLUSTRATION
*1 OIL FILTER SUB-ASSEMBLY
*2 OIL FILLER CAP SUB-ASSEMBLY
*3
SEE MORE:
INSTALLATION PROCEDURE 1. INSTALL FUEL INJECTOR SEAL
(a) Apply engine conditioner to the area shown in the illustration. Using a piece of cloth, clean carbon deposits from the fuel injector assembly and its grooves.
NOTICE:
Do not clean the tip of the fuel injector assembly.
Do n
DESCRIPTION This DTC is stored when correct destination information is not sent from the main body ECU (multiplex network body ECU) and destination information cannot be confirmed after a blind spot monitor sensor has been replaced. Blind Spot Monitor Master
DTC No. Detection Item
DTC D