Toyota Camry (XV70): Components
COMPONENTS
ILLUSTRATION
|
*1 | NO. 1 ENGINE UNDER COVER |
*2 | NO. 2 ENGINE UNDER COVER ASSEMBLY |
|
*3 | FRONT WHEEL OPENING EXTENSION PAD LH |
*4 | FRONT WHEEL OPENING EXTENSION PAD RH |
|
*5 | FRONT FENDER APRON SEAL LH |
- | - |
.png) |
N*m (kgf*cm, ft.*lbf): Specified torque |
- | - |
ILLUSTRATION
|
*1 | REFILL PLUG |
*2 | NO. 1 TRANSMISSION OIL FILLER TUBE |
|
*3 | OVERFLOW PLUG |
*4 | GASKET |
.png) |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) |
● | Non-reusable part |
.png) |
Toyota Genuine ATF WS |
- | - |
READ NEXT:
Replacement
REPLACEMENT CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced durin
Components
COMPONENTS ILLUSTRATION
*1 NO. 1 ENGINE UNDER COVER
*2 NO. 2 ENGINE UNDER COVER ASSEMBLY
*3 FRONT WHEEL OPENING EXTENSION PAD LH
*4 FRONT WHEEL OPENING EXTENSION
SEE MORE:
Front Passenger Side Power Window Switch
ComponentsCOMPONENTS ILLUSTRATION
*1 POWER WINDOW REGULATOR SWITCH ASSEMBLY
*2 POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PANEL RemovalREMOVAL PROCEDURE
1. REMOVE POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH FRONT DOOR UPPER ARMREST BASE PA
Reassembly
REASSEMBLY PROCEDURE 1. INSTALL NO. 2 STEERING RACK BOOT
(a) Apply lithium soap base glycol grease to the inside of the small opening of a new No. 2 steering rack boot.
Lithium Soap Base Glycol Grease (b) Install the No. 2 steering rack boot to the groove on the rack housi
© 2023-2026 Copyright www.tocamry.com
