Toyota Camry (XV70): Components
COMPONENTS
ILLUSTRATION
|
*1 | NO. 1 ENGINE UNDER COVER |
*2 | NO. 2 ENGINE UNDER COVER ASSEMBLY |
|
*3 | FRONT WHEEL OPENING EXTENSION PAD LH |
*4 | FRONT WHEEL OPENING EXTENSION PAD RH |
|
*5 | FRONT FENDER APRON SEAL LH |
- | - |
.png) |
N*m (kgf*cm, ft.*lbf): Specified torque |
- | - |
ILLUSTRATION
|
*1 | REFILL PLUG |
*2 | NO. 1 TRANSMISSION OIL FILLER TUBE |
|
*3 | OVERFLOW PLUG |
*4 | GASKET |
.png) |
Tightening torque for "Major areas involving basic vehicle performance such as moving/turning/stopping": N*m (kgf*cm, ft.*lbf) |
● | Non-reusable part |
.png) |
Toyota Genuine ATF WS |
- | - |
READ NEXT:
Replacement
REPLACEMENT CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced durin
SEE MORE:
Inspection
INSPECTION CAUTION / NOTICE / HINT
HINT:
Use the same procedure for bank 1 and bank 2.
The following procedure is for bank 2.
PROCEDURE 1. INSPECT CYLINDER HEAD LH (a) Using a precision straightedge and feeler gauge, check the surfaces which contact the cylinder block sub-assembly and
Brake Switch "A"/"B" Signal Cross Coupled (P05042B)
DESCRIPTION The stop light switch assembly is a duplex system that transmits two signals: STP and ST1-. These two signals are used by the ECM to monitor whether or not the brake system is working properly. If the signals, which indicate the brake pedal is being depressed and released, are detected s
© 2023-2025 Copyright www.tocamry.com
