Toyota Camry owners & service manuals

Toyota Camry (XV70): Replacement

REPLACEMENT

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during automatic transaxle fluid replacement are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced

Replaced Part or Performed Procedure

Necessary Procedure

Effect/Inoperative Function when Necessary Procedure not Performed

Link

Replacement of automatic transaxle fluid

ATF thermal degradation estimate reset

The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly.

PROCEDURE

1. REMOVE FRONT WHEEL OPENING EXTENSION PAD RH

Click here

2. REMOVE FRONT WHEEL OPENING EXTENSION PAD LH

Click here

3. REMOVE NO. 1 ENGINE UNDER COVER

Click here

4. REMOVE NO. 2 ENGINE UNDER COVER ASSEMBLY

Click here

5. REMOVE FRONT FENDER APRON SEAL LH

Click here

6. REPLACE AUTOMATIC TRANSAXLE FLUID

(a) Lift the vehicle. [#1]

NOTICE:

Set the vehicle on a lift so that the vehicle is kept level when it is lifted up (make sure the tilt angle from the front to rear and side to side of the vehicle is within +/- 1

    READ NEXT:

     Ub80f Automatic Transaxle Fluid

     Components

    COMPONENTS ILLUSTRATION *1 NO. 1 ENGINE UNDER COVER *2 NO. 2 ENGINE UNDER COVER ASSEMBLY *3 FRONT WHEEL OPENING EXTENSION PAD LH *4 FRONT WHEEL OPENING EXTENSION

     Replacement

    REPLACEMENT CAUTION / NOTICE / HINT The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced durin

    SEE MORE:

     Components

    COMPONENTS ILLUSTRATION *A for Fold Down Seat Type - - *1 REAR CENTER SEAT OUTER BELT ASSEMBLY *2 REAR SEAT CUSHION ASSEMBLY *3 REAR SEAT CUSHION LOCK HOOK *4 REAR SEAT INNER BELT ASSEMBLY RH *5 WASHER - - Tight

     Vehicle Speed Information Communication Lost (C2178)

    DESCRIPTION The tire pressure warning ECU and receiver receives signals from the combination meter assembly via CAN communication. If a malfunction occurs in this communication line, DTC C2178 is output. DTC No. Detection Item DTC Detection Condition Trouble Area Note C2178

    © 2023-2026 Copyright www.tocamry.com