Toyota Camry (XV70): Components
COMPONENTS
ILLUSTRATION
|
*1 | AIR CLEANER CAP WITH AIR CLEANER HOSE |
*2 | ENGINE COOLANT TEMPERATURE SENSOR |
|
*3 | VACUUM HOSE |
*4 | NO. 1 FUEL VAPOR FEED HOSE |
|
*5 | NO. 2 VENTILATION HOSE |
- | - |
READ NEXT:
REMOVAL CAUTION / NOTICE / HINT
The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during en
INSPECTION PROCEDURE 1. INSPECT ENGINE COOLANT TEMPERATURE SENSOR
CAUTION:
Do not put your hands into the water that has been heated for the inspection.
Touching the heated water could resu
INSTALLATION PROCEDURE 1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR
HINT: Perform "Inspection After Repair" after replacing the engine coolant temperature sensor.
Click here
(a) Apply a li
SEE MORE:
INSTALLATION PROCEDURE 1. ADJUST COMPRESSOR OIL
(a) When replacing the compressor assembly with magnetic clutch with a new one:
(1) Remove the drain bolt (seal washer) from a new compressor assembly with magnetic clutch.
*a Drain Bolt (Seal Washer)
(2
INSPECTION PROCEDURE 1. INSPECT ENGINE OIL LEVEL SENSOR
(a) Measure the resistance according to the value(s) in the table below.
Standard Resistance:
Tester Connection Condition
Specified Condition
1 - Body ground ON
Below 1 Ω
OFF 10 kΩ