Toyota Camry owners & service manuals

Toyota Camry (XV70): Components

Toyota Camry Repair Manual XV70 (2018-2024) / Engine, Hybrid System / 2gr-fks (lubrication) / Oil Pressure Switch / Components

COMPONENTS

ILLUSTRATION

*1

ENGINE OIL PRESSURE SWITCH ASSEMBLY

*2

FRONT FENDER APRON SEAL RH

*3

WIRE HARNESS PROTECTOR

-

-

N*m (kgf*cm, ft*lbf): Specified torque

Adhesive 1344

★

Precoated part

-

-

    READ NEXT:

     Removal

    REMOVAL PROCEDURE 1. REMOVE FRONT FENDER APRON SEAL RH Click here 2. DRAIN ENGINE OIL Click here 3. REMOVE ENGINE OIL PRESSURE SWITCH ASSEMBLY (a) Disengage the clamp to disco

     Inspection

    INSPECTION PROCEDURE 1. INSPECT ENGINE OIL PRESSURE SWITCH ASSEMBLY (a) Disengage the clamp to disconnect the wire harness protector. *1 Wire Harness Protector

     Installation

    INSTALLATION PROCEDURE 1. INSTALL ENGINE OIL PRESSURE SWITCH ASSEMBLY (a) Apply adhesive to 2 or 3 threads of the engine oil pressure switch assembly. Adhesive: Toyota Genuine Adhesive 1344,

    SEE MORE:

     Check Bus 3 Line for Short to +B

    DESCRIPTION There may be a short circuit between one of the CAN bus lines and +B when there is no resistance between terminal 6 (CA3H) of the central gateway ECU (network gateway ECU) and terminal 16 (BAT) of the DLC3, or terminal 21 (CA3L) of the central gateway ECU (network gateway ECU) and termin

     Reassembly

    REASSEMBLY PROCEDURE 1. INSTALL NO. 2 STEERING RACK BOOT (a) Apply lithium soap base glycol grease to the inside of the small opening of a new No. 2 steering rack boot. Lithium Soap Base Glycol Grease (b) Install the No. 2 steering rack boot to the groove on the rack housi

    © 2023-2026 Copyright www.tocamry.com