Toyota Camry owners & service manuals

Toyota Camry (XV70): Dtc Check / Clear

Toyota Camry Repair Manual XV70 (2018-2024) / Engine, Hybrid System / Cruise Control / Lane Tracing Assist System / Dtc Check / Clear

DTC CHECK / CLEAR

CHECK FOR DTC

(a) Check for DTCs (Test Failed / Pending / Confirmed).

Chassis > Lane Control > Trouble Codes

Techstream Display

Description

Test Failed

Shows the malfunction judgment results during the current trip.

Pending

Shows the malfunction judgment results up to now. (Indicates the possibility of a malfunction when no DTC is confirmed.)

Confirmed

Shows the DTCs confirmed up to now. (The number of current trips differs for each DTC.)

HINT:

Freeze frame data is stored respectively for pending DTCs, confirmed DTCs and the latest DTCs.

CLEAR DTC

(a) Clear the DTCs.

Chassis > Lane Control > Clear DTCs

HINT:

DTCs and freeze frame data are cleared at the same time.

    READ NEXT:

     Freeze Frame Data

    FREEZE FRAME DATA DESCRIPTION (a) Whenever a lane tracing assist system DTC is stored, the forward recognition camera stores the current vehicle state (ECU and sensor information) as Freeze Frame Data

     Fail-safe Chart

    FAIL-SAFE CHART FAIL-SAFE FUNCTION (a) When a malfunction occurs in the lane tracing assist system, a message is displayed on the multi-information display and control is canceled in accordance with t

     Data List / Active Test

    DATA LIST / ACTIVE TEST DATA LIST NOTICE: Some Data List values may vary significantly due to slight measurement errors, differences in the measurement environment, and changes in the vehicle over t

    SEE MORE:

     Installation

    INSTALLATION PROCEDURE 1. INSTALL ENGINE WATER PUMP ASSEMBLY (a) Install a new water pump gasket and the engine water pump assembly with the 15 bolts. Torque: Bolt (A) : 43 N·m {438 kgf·cm, 32 ft·lbf} Bolt (B) : 21 N·m {214 kgf·cm, 15 ft·lbf} Bolt (C) : 11 N·m {112 kgf·cm, 8

     Wiper and Washer Switch Circuit

    DESCRIPTION The condition of the windshield wiper switch assembly is detected and sent to the steering sensor in this circuit. WIRING DIAGRAM PROCEDURE 1. READ VALUE USING TECHSTREAM (a) Connect the Techstream to the DLC3. (b) Turn the ignition switch to ON. (c) Turn the Te

    © 2023-2026 Copyright www.tocamry.com