Toyota Camry (XV70): Freeze Frame Data
FREEZE FRAME DATA
DESCRIPTION
(a) Whenever a lane tracing assist system DTC is stored, the forward recognition camera stores the current vehicle state (ECU and sensor information) as Freeze Frame Data.
CHECK FREEZE FRAME DATA
(a) Select a DTC to display the freeze frame data.
Chassis > Lane Control > Trouble Codes(b) Check the freeze frame data for the output DTC.
FREEZE FRAME DATA CHART
Chassis > Lane Control|
Tester Display | Measurement Item |
Range | Normal Condition |
Diagnostic Note |
|---|---|---|---|---|
|
Total Distance Traveled |
- | - |
- | Cannot be used |
|
Total Distance Traveled - Unit |
- | - |
- | Cannot be used |
|
LDA Control | Whether lane tracing assist system control is permitted or not |
Prohibit or Permit | Prohibit: Lane tracing assist system control not possible Permit: Lane tracing assist system control possible |
- |
| Turn Switch (Right) |
Turn signal switch (right) status |
ON or OFF | ON: Turn signal switch on (right) OFF: Turn signal switch off (right) |
- |
| Turn Switch (Left) |
Turn signal switch (left) status |
ON or OFF | ON: Turn signal switch on (left) OFF: Turn signal switch off (left) |
- |
| Vehicle Information (2WD/4WD) |
- | - |
- | Cannot be used |
|
Vehicle Information (Conv/HV/EV) |
- | - |
- | Cannot be used |
READ NEXT:
Fail-safe Chart
FAIL-SAFE CHART FAIL-SAFE FUNCTION (a) When a malfunction occurs in the lane tracing assist system, a message is displayed on the multi-information display and control is canceled in accordance with t
Data List / Active Test
DATA LIST / ACTIVE TEST DATA LIST NOTICE:
Some Data List values may vary significantly due to slight measurement errors, differences in the measurement environment, and changes in the vehicle over t
Diagnostic Trouble Code Chart
DIAGNOSTIC TROUBLE CODE CHART Lane Tracing Assist System
DTC No. Detection Item
Link U010087
Lost Communication with ECM/PCM "A" Missing Message
U012587 Lost
SEE MORE:
Sound Signal Circuit between Radio Receiver and Stereo Component Amplifier
DESCRIPTION The radio and display receiver assembly sends a sound signal to the stereo component amplifier assembly via this circuit.
The sound signal that is sent is amplified by the stereo component amplifier assembly, and then is sent to the speakers.
If there is an open or short in this circ
Installation
INSTALLATION PROCEDURE 1. INSTALL FUEL LID LOCK WITH MOTOR ASSEMBLY
(a) Apply MP grease to the sliding parts of the fuel lid lock with motor assembly.
(b) Connect the connector. (c) Engage the claw to install the fuel lid lock with motor assembly.
(d) Engage the clamp. 2. INSTALL FUEL FILLE
