Toyota Camry (XV70): Initialization
INITIALIZATION
RESET BUB (BACK-UP BATTERY) CONDITION
HINT:
If the BUB (Back-Up Battery) has been replaced, it is necessary to perform the Reset Backup Battery Condition procedure.
(a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG).
(c) Turn the Techstream on.
(d) Choose "Telematics" from the System Selection Menu, and then click "Utility".
(e) Click "Backup Battery Replacement Reset" on the Utility Selection Menu.
Body Electrical > Telematics > Utility|
Tester Display |
|---|
| Backup Battery Replacement Reset |
(f) According to the display on the Techstream, perform Backup Battery Replacement Reset to reset the BUB (Back-Up Battery) replacement flag.
READ NEXT:
Problem Symptoms Table
PROBLEM SYMPTOMS TABLE
HINT:
Use the table below to help determine the cause of problem symptoms. If multiple suspected areas are listed, the potential causes of the symptoms are listed in order
Terminals Of Ecu
TERMINALS OF ECU
Terminal No. (Symbol) Wiring Color
Terminal Description Condition
Specified Condition
K140-1 (+B) - K140-20 (E)
B - W-B Power source (+B)
Dtc Check / Clear
DTC CHECK / CLEAR CHECK DTC (a) Connect the Techstream to the DLC3.
(b) Turn the engine switch on (IG). (c) Turn the Techstream on.
(d) Enter the following menus: Body Electrical / Telematics / Tr
SEE MORE:
On-vehicle Inspection
ON-VEHICLE INSPECTION CAUTION / NOTICE / HINT
NOTICE: If the battery is weak or if the engine is difficult to start, recharge the battery and perform inspections again before returning the vehicle to the customer. PROCEDURE
1. CHECK BATTERY CONDITION (a) Check the battery for damage or deformati
Terminals Of Ecu
TERMINALS OF ECU TERMINALS OF ECU
*a Component without harness connected
(Rack and Pinion Power Steering Gear Assembly)
- -
HINT:
The rack and pinion power steering gear assembly uses waterproof connectors. Therefore, voltage or waveforms cannot be checked wit
© 2023-2026 Copyright www.tocamry.com
